Wj-Hd500 Series Control (Ps·data); Controlling The Recorder With A Ps·data System Controller - Panasonic WJ-SX 150A Operating Instructions Manual

WJ-HD500 SERIES CONTROL (PS·DATA)
This section will describe what you should take notice when using a PS·Data system controller.
The same descriptions as the system controller's operating instructions are not mentioned here. Refer to them.
Controlling the Recorder with a PS·Data System Controller
Recorder Mode
Before operating the recorder, it is necessary to enter the recorder mode.
1. Select the desired monitor. (Refer to p. 125 Monitor Selection.)
2. In the PS·Data mode, a number is assigned to each recorder. To select a desired recorder, enter the corresponding num-
ber by pressing the numeric buttons.
Recorder
Master recorder
Slave 1 recorder
Slave 2 recorder
Slave 3 recorder
Slave 4 recorder
3. Press the CAM button.
The recorder image will be displayed on the selected monitor, and you will enter the recorder mode.
Operations
1. Press the SHIFT button to activate the FUNCTION buttons.
2. Enter the desired function code, and then press the FUNCTION button. (Refer to the diagram.)
Function
Forward field advance
Backward field advance
Pause
Playback
Recording
Stop recording and playback
Stop playback
Stop recording
Search forward
Search backward
Displaying a recorder's OSD
3. To select a camera channel, press the numeric button(s), then CAM button. The system will exit from the recorder mode,
and the selected camera image will be displayed on the monitor.
Notes:
• Only one operator can enter the recording mode.
• The images from the recorder, which are displayed on the monitor, is conformed to the recorder setting.
• You cannot skip to the previous/next record by moving the joystick.
141
Number
100
101
102
103
104
Code Note
1 Available only during pause
2 Available only during pause
4
5
6 Equal to the REC button of the recorder
8
9 Exclusive use to stop playback
10 Exclusive use to stop recording
11
12
19 Pressing again will hide the display.