Panasonic WJ-SX 150A Operating Instructions Manual page 146

Problem
The alarm mode is not activated.
ACK or RESET is not activated.
Timer event is not activated.
SETUP MENU does not open.
The system does not enter the recorder
mode.
"NOT ASSIGN" is displayed beside the
camera number on the monitor.
"Initializing..." is displayed on monitors.
(For WJ-HD500 Series recorders) You
cannot search for records even when car-
rying out the Search Playback procedure.
Recording or playback with the recorder
is not correctly carried out.
150
Check item
The alarm mode is set to OFF.
The port for an alarm input is set to
OFF.
When "ALM SUSPENDED" is displayed
on the monitor, the alarm is suspended.
SETUP MENU may be open.
You may not have selected the alarm-
related monitor.
The system controller is not authorized
to select the monitor.
You are not authorized to reset an
alarm.
While the PROHIBITED indicator is
lighting on the system controller, you
are prohibited to control the monitor.
A higher-priority operator may have
selected the event-related monitor.
When the PROHIBITED indicator is light-
ing on the system controller, you are pro-
hibited to open SETUP MENU.
The recorder connection may be
wrong.
The connected recorder may not con-
form to the unit.
You are not authorized to operate the
recorder.
When you select the LCN (logical cam-
era number) not assigned in the system,
"NOT ASSIGN" will appear.
If connections or settings are wrong, this
message, SLAVE n*, and the firmware
version will be displayed after you turn
on a Slave recorder.
*n is a unit number.
"Error" or "TIME OUT" may be displayed
after pressing the PLAY button in the
date-and-time entry form.
Camera number settings are wrong.
Remedy
Set the alarm mode to SEQUENCE or
HOLD in SETUP MENU or WJ-SX150A
Administrator Console.
SETUP MENU: Refer to p. 67.
Administrator Console: Refer to p. 88.
Set the alarm port to ON in SETUP
MENU or WJ-SX150A Administrator
Console.
SETUP MENU: Refer to pp. 68 to 69
Administrator Console: Refer to p. 88.
Press the ACK/SUSPEND button while
holding down the SHIFT button to can-
cel the alarm suspension.
Press the SETUP button while holding
down the SHIFT button to close SETUP
MENU.
Select the monitor again. (Refer to pp.
106 or 125.)
Confirm the Monitor Selection window in
WJ-SX150A Administrator Console and
reconfigure the setting if necessary.
(Refer to p. 92.)
Confirm the Level Table window in WJ-
SX150A Administrator Console and
reconfigure the setting if necessary.
(Refer to p. 91.)
Open the Monitor Selection window
(refer to p. 92) and reconfigure the set-
ting if necessary.
Select another monitor.
Open the Level Table window (refer to
p. 91) and reconfigure the setting.
Connect the recommended recorder to
the unit.
Confirm the recorder connection (refer
to pp. 40 to 47.)
Open the Level Table window (refer to
p. 91) and reconfigure the setting.
Select an assigned logical camera num-
ber. (Refer to p. 107.)
Confirm the connections (refer to pp. 33
to 55) and settings (refer to pp. 57 to
102).
The date-and-time entry form is unavail-
able. Use Record List or Thumbnail
Display to search for records.
Conform the LCN (logical camera num-
ber) settings of the unit and camera
number settings of the recorder.