Panasonic WJ-SX 150A Operating Instructions Manual page 174

Note: The factory default setting is 150.
4. To select your registered password (up to 5 digits),
press the numeric buttons, then press the CAM (SET)
button.
The factory default setting is "150".
If the operator ID and password are correct, "Login OK"
will blink on the LCD for about 3 seconds. Then, "Mon -"
"Cam - -" will appear on the LED display.
User ID
Password
Mon- Cam--
Note: If an operator ID or password error occurs,
"Invalid" will blink on the LCD for about 3 seconds.
Then, return to Step 3 and select your operator ID.
■ Operation Start (Auto Login)
If the auto login is set to ON, any operators can log into the
system automatically. After the controller is turned on,
"AUTO" appears on the LCD for approximately 2 seconds,
then "Mon -" "Cam - -" automatically appears.
Auto login is configurable
Administrator Console. (Refer to the operating instructions
of matrix switcher.)
Mon- Cam--
■ Operation End (Logout)
This operation is skipped when the auto logout is set to ON.
This function is used when an operator leaves the controller
or no longer requires access to the system.
To log out of the system, press the MON LOCK/LOGOUT
button while holding down the SHIFT button.
"Logout" will blink on the LCD for about 3 seconds. Then,
"Terminal Mode No User" appears on the LCD.
Terminal Mode
No User
2
150
__∗ ∗ ∗
Invalid
Blinking
through WJ-SX150A
Note: If you want to save the power consumption, discon-
nect the DC 9 V plug from the controller, and remove
the AC adapter from the AC outlet.
■ Operation End (Auto Logout)
If the auto logout is set to ON and no operation takes place
for a specific time, any operators can logout automatically.
After the logout, "Terminal Mode No User" automatically
appears on the LCD.
Terminal Mode
No User
You can activate auto logout and set up the duration until
logout (configurable by minute) through WJ-SX150A
Administrator Console. (Refer to the operating instructions
of matrix switcher.)