Panasonic WJ-SX 150A Operating Instructions Manual page 173

Addendum for WV-CU650 and WJ-SX150 Series
The descriptions in this document are applicable when WJ-SX150A Administrator Console and the firmware of this unit (matrix
switcher) are Ver. 2.03 or later.
Note: Refer to the operating instructions of matrix switcher for how to check the version.
(1) ADDENDUM FOR SYSTEM CONTROLLER WV-CU650:
MATRIX SWITCHER WJ-SX150 SERIES
OPERATING PROCEDURES
INSTALLATIONS AND CONNECTIONS
■ Basic System Connections
• The connection details are the same as System
Controller WV-CU360C/CJ. Refer to the operating
instructions of matrix switcher .
• To connect System Controller WV-CU650 to Digital Disk
Recorder WJ-HD300 Series or WJ-HD220 Series via the
matrix switcher, refer to pp. 37 to 39.
SETUP PROCEDURES (HARDWARE)
■ MODE Switch Setting
Either of the terminal mode or PS·Data mode are applicable
for connections. Refer to WV-CU650 Operating Instructions
for details on the switch setting for each mode.
BEFORE OPERATION
Note: This section describes the terminal mode. To operate
in the PS·Data mode, refer to the operating instructions.
Before starting the following procedures, all system compo-
nents must be turned on.
The following procedures are applicable when the system
controller is connected to the matrix switcher.
■ Operation Start (Login)
Note: When auto login is set to ON, operators can log into
the system without entering their passwords. (Refer to
p. 2 Operation Start (Auto Login).)
This operation is skipped when the auto login is set to ON.
(Refer to the operating instructions of matrix switcher.)
1. Turn on the power switches of all system components.
The OPERATE indicator will light up.
■ CONTROLLER NO. Switch
Setting
Normally, set this switch to "1" (default position).
2. To turn on the power of the system controller, connect
the AC adapter to the AC outlet.
The OPERATE indicator lights up and "Terminal Mode
No User" appears on the LCD.
Terminal Mode
No User
3. To select your registered operator ID number (1 to 16,
up to 2 digits), press the numeric buttons, then press
the CAM (SET) button.
"Password" entry form appears on the LCD.
User ID
Password
150
_____