Installations; Mounting Into The Rack; Installing The Multiplexer Board Mux - Panasonic WJ-SX 150A Operating Instructions Manual

INSTALLATIONS

WARNING
The installations described in the figures should be
made by qualified service personnel or system
installers.

Mounting into the Rack

The matrix switcher can be mounted into the rack as
described.
1. Remove the four rubber feet by unwinding the four
screws on the bottom of the matrix switcher.
Remove 4 rubber feet
2. Place the rack mounting brackets on both sides of the
matrix switcher and tighten with the four supplied
screws (M4 X10).
3. Install the matrix switcher in the rack with the rack
mounting brackets secured with four screws (procured
locally).
32
Notes:
• An optional cooling fan attached inside the unit is
subject to wear. It needs to be replaced periodical-
ly.
Keep the temperature in the rack below 45 °C
(113 °F) at any time.
• If the rack is subject to vibration, secure the rear of
the appliance to the rack by using additional mount-
ing brackets (procured locally).
Installing the Multiplexer Board
MUX
To use WJ-HD100 Series or a time-lapse VCR as a
recorder, you need to install a Multiplexer board inside the
matrix switcher. Refer to the Multiplexer board's operating
instructions for how to install.