Yamaha RS7000 Owner's Manual page 124

12. Saving to Memory Card or Disk
Formats memory cards and disks.
Format Procedure
Press the [SAVE] button 5 times from the PATTERN Play or
1.
Patch mode to go to the Format page.
Press [F1] (CARD/SCSI) to specify whether you want to for-
2.
mat a memory card or disk.
If a SCSI disk is selected, use [Knob 3] to select the type of
3.
formatting you want to apply.
NOTE
Normally when formatting a hard disk, ZIP disk,
etc., it is best to start with LOGICAL formatting.
If LOGICAL formatting produces an error, then
try PHYSICAL formatting.
When the PARTITION format type is selected, use [Knob 4]
4.
to select the disk partition to be formatted.
Press [F4] to begin the format operation.
5.
The "Are you sure? NO[F2]/YES[F3]" confirmation message
6.
will appear.
Press [F3] if it is OK to go ahead with the format operation.
Press [F2] to abort the format operation.
Press [EXIT] 5 times to return to the PATTERN Play or Patch
7.
mode.
NOTE
• The format operation erases all data from the
target card or disk and is irreversible. Proceed
with caution.
• Before using the above procedure to format a
SCSI disk you will need to:
1. Press [LOAD] 3 times from the PATTERN
Play or Patch mode to display the SCSI
Setup page.
2. Use [Knob 1] (MOUNT ID) to set the
RS7000 SCSI ID number.
124 RS7000
[5] Format Page
Display Parameters
CARD or DISK = SCSI
Partition Name
SCSI ID
Icon
Disk Type
1
[F1] [Knob 3]
CARD or DISK = CARD
1
[F1]
SCSI/CARD
1
................................................................... [F1]
[Settings] SCSI, CARD
SCSI .............. The hard disk, ZIP disk, or other
SCSI disk connected to the SCSI
connector.
CARD ............ A memory card inserted in the
card slot.
Selects the disk or memory card to be formatted.
When CARD is selected and a properly formatted memory
card is in the card slot, a memory card icon will appear.
When SCSI is selected and a properly formatted disk is con-
nected to the SCSI connector, a disk icon will appear along
with the disk description, SCSI ID number, and partition
name.
[PATTERN] → [SAVE] × 5
2 3 4
[Knob 4] [F4]
4
[F4]