Modify Gate Time - Yamaha RS7000 Owner's Manual

4 Rate
[Settings] 000% ~ 200%, ***
Specifies the percentage by which the target notes will be
shifted from their original velocities.
Settings below 100% reduce the velocities, and settings
above 100% increase the velocities proportionately. When
the Set All parameter is not "OFF" this parameter appears as
"***" and cannot be changed.
Original velocity
(Vel)
96
Rate = 50%
(Vel)
48
(Vel)
Rate = 150%
127
5 Offset
[Settings] -127 ~ +127, ***
Adds a fixed value to the Rate-adjusted velocity values.
A setting of 0 produces no change. Settings below 0 reduce
the velocities, and settings above 0 increase the velocities.
When the Set All parameter is not "OFF" this parameter
appears as "***" and cannot be changed.
Original velocity
(Vel)
96
Rate = -20
(Vel)
76
(Vel)
Rate = +20
116

03 Modify Gate Time

This job alters the gate times of the specified range of notes.
Gate time changes are calculated as follows:
Adjusted gate time =
(original gate time × Rate) + Offset
If the result is 0 or less, the value is set to 1.
1 2
4 3
[Knob 2]
64 48 32
32 24 16
96 72 48
64 48 32
44 28 12
84 68 52
5
[Knob 3] [F4]
14. Pattern & Phrase Editing — The Pattern Jobs
1 Phrase
[Settings] 001 ~ 256
Range
2
[Settings] Measure:Beat:Clock
001:1:000 ~ 257:1:000
Sets the range of measures/beats/clocks over which the job is
applied.
Set All
3
[Settings] Off (0), 0001 ~ 9999
Sets the gate times of all target notes to the same fixed value.
When set to "OFF" the Set All parameter has no effect.
When set to a value other than "OFF" the Rate and Offset
parameters are unavailable and appear as "***" on the dis-
play.
Rate
4
[Settings] 000% ~ 200%, ***
Specifies the percentage by which the gate time of the target
notes will be changed.
Settings below 100% shorten the notes, and settings above
100% lengthen the notes proportionately. When the Set All
parameter is not "OFF" this parameter appears as "***" and
cannot be changed.
Original gate time
(Gate)
Gate time rate = 50%
(Gate)
Gate time rate = 150%
(Gate)
Offset
5
[Settings] -9999 ~ +9999, ****
Adds a fixed value to the Rate-adjusted gate time values.
A setting of 0 produces no change. Settings below 0 shorten
the gate time, and settings above 0 lengthen the gate time.
When the Set All parameter is not "OFF" this parameter
appears as "****" and cannot be changed.
Original gate time
(Gate)
32
Offset = -20
(Gate)
12
Offset = +20 (Gate)
52
32 32 32 48
16 16 16 24
48 48 48 72
32 32 48
12 12 28
52 52 68
RS7000 137
2