The Pattern Chain Jobs - Yamaha RS7000 Owner's Manual

6. The Pattern Chain Jobs

The RS7000's 9 pattern chain "jobs" can be used to edit and modify pattern chain data in a number of
ways.
G Job List
[Undo/Redo Category]
00 Undo/Redo
[Event Category]
01 Copy Event
02 Erase Event
[Measure Category]
03 Create Measure
04 Delete Measure
[Convert Category]
05 Convert To Song
[Chain Category]
06 Copy Chain
07 Clear Chain
08 Chain Name
Pattern Chain Job Procedure
Category
[Knob 1] [Knob 2]
Press the [JOB] button from the PATTERN Chain Play mode
1.
to go to the job list.
Use [Knob 1] (CATEGORY) and [Knob 2] (JOB) to move the
2.
cursor to the desired job.
Press [F4] (SELECT) to jump to the selected job page.
3.
Use [Knob 2] (CURSOR ← →) to move the cursor to the var-
4.
ious parameters, and [Knob 3] (VALUE -/+) or [SHIFT]+[F3]
→ Numeric Keypad to set the parameter values as required.
Undo cancels the changes made by the most recent opera-
tion, restoring the data to its previous state, while Redo
restores the "undone" change.
Copies all data from a specified source range to a specified
destination location.
Clears all events from the specified range.
Creates empty measures at the specified location.
Deletes the specified measure(s).
Converts the current pattern chain to performance data and
copies the data to a specified song.
This job copies all data from a selected source pattern chain
to a selected destination pattern chain.
This job deletes all data from the selected pattern chain.
Use this job to enter or change a pattern chain name.
Job
[F4]
When the parameters are set press [F4] (DO!) to execute the
5.
job. "Completed." will appear when the job is done.
Press [EXIT] twice to go back to the PATTERN Play or Patch
6.
mode.
NOTE
If the memory protect function is ON, "Memory
Protected" will appear on the display when the
[JOB] button is pressed and it will not be possi-
ble to access the job list. In this case go to the
UTILITY mode System page (Page 257) and
turn MEMORY PROTECT "OFF".
Precautions
• If there is no data in the specified range "No Data" will appear
on the display and the job can not be executed.
• If you make a mistake or want to compare the sound of the
data before and after executing a job, use the Undo/Redo func-
tion (Page 172).

6. The Pattern Chain Jobs

P.172
P.172
P.172
P.173
P.173
P.173
P.174
P.174
P.174
RS7000 171
3