Table of Contents
Advertisement
4.3.2 Level adjusting
(1) Tools
a. A level scale, with tolerance within 0.02mm/m
b. Spanners, Level adjusting blocks.
(2) Procedure
1. The level adjusting bolts.
`
4.3.3 The installation of the electricity
a. Prepare long enough wire. (about 30 meters). The diameters for all the models
are as follows:
b. Connect L1、L2 and L3 to the main power switch.
c. Connect the ground wire to PE base.
Note: The following are the main power switches and its other relating data.
Item
Cross-sectional area of phase
Type
220V 380V 415V 440V
TPR-1230
3.5
TPR-1230H
3.5
TPR-1600H
5.5
TPR-2000H
5.5
4.4 The test after installation
a. Have the main power on.
b. Press the emergent stop button to see whether it stops immediately.
c. Power on again.
d Please check whether the motor is running smoothly. If there is any errors,
Please select two of the wires L1, L2 and L3 and change its position.
e
Check every mechanism to see whether it works normally.
4.5 The procedure for dismantling the machine
The dismantling procedure is the reverse of the installation one.
Power supply AC±10%1Φ 50/60HZ±1HZ
conductors supplying the
equipment` (mm
3.5
3.5
3.5
3.5
3.5
3.5
5.5
5.5
5.5
5.5
5.5
5.5
a. Please adjust the level adjusting bolts to
contact the level adjusting blocks.
b
Have the level scale put on the worktable.
.
c. Locate the peak point using the level scale and
make it as a reference level.
d
Adjust the tolerance of the level adjusting
.
bolts to be within one grad using the level
adjusting scale.
Rated current
2
)
PE
220V 380V 415V 440V
3.5
19.3
3.5
19.7
5.5
34.8
5.5
37.8
4-4
(A)
11.12 10.2
9.7
11.89 11.04 10.33
19.95 18.59 17.38
21.65
21
20
Power
equipment
capacity
(KVA)
9.753
9.753
20.203
22.193
Advertisement
Table of Contents
