Table of Contents
Advertisement
5.3.3
Universal clamp and the clamping of the work piece.
Clamp the work piece as the following： （Since the combination of the universal clamp is very
flexible and abundant, The following diagram is applied as an exemplary description.
a. Move away the drilling bit or lift the gearbox to the utmost point.
b. Using brush, clean the worktable and the vise surface.
c. Clean the vise surface using clean rag.
d. Position the work piece on the vise surface. If it is piercing drilling, please insert a block under the
work piece so that drilling into vise can be avoided.
e. After screwing the T shape chamfer nut to the twin head bolts with suitable length, put it into the T
shape chamfer of the worktable or the base.
f. Choose the insertion block or ladder block that is the same high as work flange. Put them in the
other side of the bolts.
g. Using holed stacking block, place them onto the bolts, with one of its side pressing the work flange
and another pressing the insertion block or ladder block, then tighten it with hex nuts.
Examples of clamping, using the universal clamp.
（1） Hex nuts
（2） T shape chamfer nuts
（3） Stacking plate
（4） Twin head bolts
（5） Insertion block
（6） Ladder block
1.
Drilling bit
2.
Work piece
3.
Stacking block
4.
Insertion block
5.
Twin head bolts
6.
T shape chamfer bolts
7.
Worktable
8.
Hex but
5-10
Advertisement
Table of Contents
