Sony PCWA-C100 Owner's Manual page 62

Wireless lan pc card

Hide thumbs Also See for PCWA-C100:

Table of Contents

Additional information

❑

Communication between the Access Point and your computer are not established. Check the

communication status using the Wireless Palette.

❑

The Access Point is not properly configured. Configure the Access Point with the connection mode of

your choice using one of the Access Point setup utilities.

❑

The Access Point and your computer are too far apart [more than approximately 100 m (330 feet)]. When

the Wireless Palette shows the

The data transfer speed is slow.

❑

There is radio interference with another Access Point. Try assigning another channel number using one

of the Access Point setup utilities.

❑

There are too many clients logging on the Access Point. Try later.

I cannot remember the Encryption Key.

Proceed as follows:

Set the Access Point in the Software Reset mode.

Change the Encryption Key using the Access Point Setup Utility.

For further information about the Software Reset mode, see the Troubleshooting section of the

Wireless Palette Help file or the Custom Access Point Setup Utility Help file.

I cannot restore communication with the Access Point even after performing a software reset.

To reset the Access Point, proceed as follows:

Use the Access Point Firmware Upgrade Utility to restore the factory configuration of the Access Point.

In order to reset:

❑

Connect the Access Point to the power supply while pressing the reset switch on the bottom side of

the Access Point.

❑

Release the switch when the orange POWER indicator lights on.

Use the Wireless Palette to register the settings of the Access Point and establish communications with it.

icon, move your computer closer to the Access Point.

n N

Table of Contents