Sony PCWA-C100 Owner's Manual page 63

Additional information
3 Use the Access Point Setup Utility to make settings for the Access Point.
The Wireless Palette still shows the previous computer name after a change.
❑
The Access Point has not yet recognized the new computer name. Click the Nickname of the Access Point
in the Tool Box window of the Wireless Palette, then click Select. If the correct information is displayed,
click OK.
The communication band is supposed to be 11 Mbps, but MPEG2 data transfer fails.
❑
11 Mbps is a logical value. The actual value is approximately 4 to 5 Mbps. This occurs with almost all
IEEE 802.11 compliant products. The high-speed stream transfer of MPEG2 may cause a reduction of
communication band.
No communication is available even though my computer is located within 100 m (330 feet) of
the Access Point.
❑
The actual communication distance depends on the installation site and surrounding conditions. Move
your computer closer to the Access Point.
The data transfer speed has become slower.
❑
The actual data transfer speed may change depending on the distance and quality of the link. The data
transfer speed is 11 Mbps (maximum) but may fall to 5.5 Mbps, 2 Mbps, or 1 Mbps in certain conditions.
n N
62