Panasonic NP-6F1MLQ Operating And Installation Instructions page 15

Using the Dishwasher
1
1. To open the Rinse Aid Dispenser, turn the Cap to the "open" (anti-clockwise) and lift
it out.
2. Pour the rinse aid into the dispenser, being careful not to overfi ll.
3. Replace the Cap by inserting it aligned with "open" arrow and turning it to the closed
(clockwise).
■
Note:
Clean up any rinse aid spilled while during fi lling with an absorbent cloth to avoid
excessive foaming during the next wash. Don't forget to replace the Cap before closing
the Dishwasher door.
Adjusting Rinse Aid Dispenser
The Rinse Aid Dispenser has six settings. Always start
with the dispenser set on "4". If still facing spots and
poor drying problem, increase the amount of rinse aid
dispensing by removing the Cap and rotating the dial
to "5". If the dishes are still not drying properly or spots
remain, adjust the dial to the next higher level until the
dishes are spot-free. The recommended setting is "4".
(Default value is "4".)
■
Note:
Increase the dose if there are drops of water or lime spots on the dishware after
washing. Reduce it if there are sticky whitish stains on dishware or a bluish fi lm on
glassware or knife blades.
Dishwasher_NP-6F1MLQ.indb 15 Dishwasher_NP-6F1MLQ.indb 15
2 3
Rinse Aid
Adjust Level
7/19/2016 5:21:04 PM 7/19/2016 5:21:04 PM
15