Water Connection - Panasonic NP-6F1MLQ Operating And Installation Instructions

Installation Instruction
electrical socket to which the Dishwasher must be connected is not appropriate for the
Power Plug, replace the socket, rather than using adapters or the like as they could cause
overheating and fi re.
Inlet Pipe Connection
■
Note:
• The maximum inlet water pressure is 1 MPa.
• The minimum inlet water pressure is 0.04 MPa.
The appliance is to be connected to the water mains by new detachable hose-
sets supplied with the appliance. Old hose-sets should not be used.
Close the water tap after using.
Drain Pipe Connection
Insert the Drain Pipe into a drain with a minimum diameter of Ø40 mm. Make sure to avoid
bending or crimping it.
Dishwasher_NP-6F1MLQ.indb 37 Dishwasher_NP-6F1MLQ.indb 37

Water Connection

Connect the Inlet Pipe to a threaded 3/4 (inch) connector and
make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that the
water is clean. This precaution is needed to avoid the risk of the
water inlet to be blocked and damage the Dishwasher.
CAUTION
For Installer
Counter
Ø
40 mm
37
7/19/2016 5:21:10 PM 7/19/2016 5:21:10 PM