Panasonic NP-6F1MLQ Operating And Installation Instructions page 24

Using the Dishwasher
Starting a Wash Cycle
1. Insert Power Plug to the mains socket. Switch ON the main switch on the wall. Fully
open the Dishwasher door.
2. Fill in the detergent and rinse aid. Fill in the salt into the Salt Container (if necessary)
by drawing out the Lower Basket.
3. Draw out the Lower Basket, Upper Basket and Cutlery Basket. Load the dishware to
the baskets and push them back.
4. Fully close the Dishwasher door. Turn ON the water supply.
5. Turn ON the Dishwasher by pressing OFF/ON button follow by the Programme
Selection button. The wash programme sequence will be:
Auto --> Intensive --> Normal --> Eco --> Glass --> 90 min --> Rapid --> Soak.
If a programme is selected, the icon light will light up and the time needed to run the
wash cycle will show on the Control Panel.
6. Press the Pause/Start button to start the washing.
(" : " in the time display will blink if the washing is started, " : " in the time display will
stop blinking when washing is stopped or paused.)
Change the Programme
1. A cycle that is underway can be modifi ed only if it has been running for a short time.
Otherwise, the detergent may have already been released, and the Dishwasher may
have already drained the wash water. In this case, the detergent dispenser must be
refi lled (see the section titled "Fill in Detergent").
2. Press the Pause/Start button then press the Programme Selection button for more
than 3 seconds to cancel the running programme.
3. Select a new programme.
4. Restart the Dishwasher by pressing the Pause/Start button.
■
Note:
If the door is opened during a wash cycle, the Dishwasher will pause. When the door is
closed, the Dishwasher will resume working after approximately 10 seconds.
Adding Dishware during Operation
Dishware can be added at any time before the Detergent Dispenser opens.
1. Press the Pause/Start button to stop the Dishwasher.
2. Open the Dishwasher door and add the dishware in the Dishwasher.
3. Close the Dishwasher door. Then, press the Pause/Start button. The Dishwasher will
run after approximately 10 seconds.
24
Dishwasher_NP-6F1MLQ.indb 24 Dishwasher_NP-6F1MLQ.indb 24 7/19/2016 5:21:06 PM 7/19/2016 5:21:06 PM