Troubleshooting - Panasonic NP-6F1MLQ Operating And Installation Instructions

Troubleshooting

Problem
Dishwasher
does not
start
Technical
problems
Water not
pumped from
Dishwasher
Suds in the
tub
Stained tub
interior
General
White fi lm
problems
on inside
surface
There are
rust stains
on cutlery
Knocking
noise in the
wash cabinet
Rattling
Noise noise in the
wash cabinet
Knocking
noise in the
water pipes
30
Dishwasher_NP-6F1MLQ.indb 30 Dishwasher_NP-6F1MLQ.indb 30
Possible Causes What To Do
Fuse blown, or the circuit Replace fuse or reset circuit breaker. Remove any
breaker acted. other appliances sharing the same circuit with the
Dishwasher.
Power supply is not turned Make sure the Dishwasher is turned ON and the door
ON. is closed securely.
Make sure the power cord is properly plugged into the
wall socket.
Water pressure is low. Check that the water supply is connected properly and
the water is turned ON.
Door of Dishwasher not Make sure to close the door properly and latch it.
properly closed.
Twist in Drain Pipe. Check Drain Pipe.
Filter clogged. Check the Coarse Filter.
(See section titled "Cleaning the Filter").
Kitchen sink clogged. Check the kitchen sink to make sure it is draining well.
If the problem is the kitchen sink not draining, you
may need a plumber rather than a serviceman for
Dishwashers.
Improper detergent. Use only the special Dishwasher detergent to avoid
suds. If this occurs, open the Dishwasher and let suds
evaporate.
Add 1 gallon of cold water to the tub. Close and latch
the Dishwasher, then select any cycle.
Dishwasher will drain out the water at the fi rst step.
Open the door after draining is stop and check if the
suds is disappeared.
Repeat if necessary.
Spilled rinse-aid. Always wipe up rinse-aid spills immediately.
Detergent with colourant Make sure that the detergent is the one without
was used. colourant.
Hard water minerals. To clean the interior, use a damp sponge with
Dishwasher detergent and wear rubber gloves.
Never use any other cleaner than Dishwasher
detergent for the risk of foaming or suds.
The affected items are not corrosion resistant.
A programme was not run Always run the quick wash programme without any
after Dishwasher salt was crockery in the Dishwasher and without selecting the
added. Turbo function (if present), after adding Dishwasher
Traces of salt have gotten salt.
into the wash cycle.
The lid of the Salt Check the lid. Ensure the fi x is fi ne.
Container is loose.
A spray arm is knocking Interrupt the programme, and rearrange the items
against an item in a which are obstructing the spray arm.
basket.
Items of crockery are loose Interrupt the programme, and rearrange the items of
in the wash cabinet. crockery.
This may be caused by This has no infl uence on the Dishwasher function.
on-site installation or the If in doubt, contact a suitably qualifi ed plumber.
cross-section of the piping.
7/19/2016 5:21:08 PM 7/19/2016 5:21:08 PM