GE Dash Port 2 Service Manual page 64

Problem
The monitor IS NOT communicating with
the Unity Network.
The docking station's illuminated
communication indicator is green.
The monitor IS NOT communicating with
the Unity Network.
The docking station's illuminated
communication indicator is flashing
amber.
The monitor IS NOT communicating with
the Unity Network.
The docking station's illuminated
communication indicator is green.
5-6
Troubleshooting: Troubleshooting Procedures
Problems and Solutions Table
Cause
The network cable is damaged.
The docking station or the monitor is
defective.
The network cable is connected to the
monitor instead of the docking station.
Dash Port 2 Docking Station
2000966-138
Solution
1. Disconnect the network cable from the
docking station.
2. Remove the monitor from the docking
station and connect the network cable to
the monitor.
3. If the monitor cannot view a remote bed
from the network:
Replace the network cable.
Investigate the network for network
problems.
4. If the monitor can view a remote bed
from the network the docking station's
PCB must be replaced. See,
the Connector Assembly FRU or PCB
FRU" on page 6-19.
1. Remove the monitor from the docking
station.
2. Manually depress the locking lever pin
and slide the security lever to the far left
position.
3. Verify the AC power/communication
mechanism extends out of the docking
station's base and locks into position.
4. If the AC power/communication
mechanism does NOT extend out of the
docking station's base, see "The AC
power/communication mechanism does
NOT extend out of the docking station's
base." on page 5-10.
5. If the AC power/communication
mechanism extends out of the docking
station's base, then complete the
following tasks.
a. Replace the docking station with a
known good docking station.
b. If the monitor now communicates with
the Unity Network, then the docking
station's PCB must be replaced. See,
"Replace the Connector Assembly
FRU or PCB FRU" on page 6-19.
c. If the monitor still does NOT
communicate with the Unity Network,
replace the monitor.
Disconnect the network cable from the
monitor and reconnect it to the docking
station.
"Replace
Revision A