GE Dash Port 2 Service Manual page 65

Problem
The monitor is NOT communicating with
the auxiliary device.
Revision A
Troubleshooting: Troubleshooting Procedures
Problems and Solutions Table
Cause
The monitor does not support the auxiliary
device.
The monitor's software version does not
support the AUX 2 connector on the
docking station.
The auxiliary cable is damaged.
The auxiliary device may need to be
configured to function with a docking
station.
Dash Port 2 Docking Station
2000966-138
Solution
Use a monitor that supports the auxiliary
device. See "Compatible Auxiliary Devices"
on page 2-10.
To use the AUX 2 connector on the
docking station, the monitor must use Dash
3000/4000 software version 5.0 or later.
See "Compatible Dash Monitors"
page 2-9.
1. Disconnect the auxiliary cable from the
docking station.
2. Connect the auxiliary cable to the
monitor.
3. If the monitor cannot communicate with
the auxiliary device, replace the auxiliary
cable.
See the Dash Patient Monitor Operator's
Manual and the operator's manual
provided with the auxiliary device for
configuration recommendations.
on
5-7