Setting Up Nc Card And Device Driver (Isa Nc Card); Installing Nc System Device Driver For Windows 95; Installing Nc System Device Driver - Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual

Table of Contents

4.3 Setting up NC Card and Device Driver (ISA NC Card)

This chapter describes the installation of NC System Device Driver for ISA NC Card and the

procedures for mounting NC Card. (For PCI NC Card, refer to chapter 4.2)

CAUTION

Be sure to install NC System Device Driver before mounting NC Card on the expansion slot of

the personal computer.

If NC Card has already been mounted on the personal computer, unplug the personal computer

and remove NC Card before installing the software.

By installing NC System Device Driver, the device driver for the NC Card and MELDASMAGIC64 NC

System Software are installed.

The installation procedures of NC System Device Driver differ by each Windows model.

For Windows95, refer to chapter 4.3.1. For Windows98 (including Second Edition), refer to chapter

4.3.2. For WindowsNT, refer to chapter 4.3.3.

Install NC System Device Driver according to the procedures below.

Install Device Driver using a hardware wizard. (Hardware is not detected automatically.)

[Procedures]

(1) Click the [Settings] - [Control Panel] menus of the [Start] menu on the task bar.

(2) When the "Control Panel" window is displayed, double-click the "Add New Hardware" icon.

Downloaded from

ManualsNet.com

4. Setting up MELDASMAGIC64 System

4.3 Setting Up NC Card and Device Driver (ISA Card)

search engine

Table of Contents

Cnc meldasmagic64