Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual page 73

(2) Click the [Settings] tab, and then input NC Card No.
Set an NC Card No. in [NC Card Number(01-FF): &h] of [Configuration]. The setup range for an NC
Card No. is 01-FF in hex. If one NC Card is used only, set 01 normally.
Example: NC Card Number (01-FF): &h01
Note: When reinstalling or upgrading NC System Device Driver, set the same NC Card No. as the one
used so far. If a different NC Card No. is set, the environment setup may be erased.
(3) Click the [OK] button.
Operation: The "Properties" window is closed.
(4) Close [Device Manager].
After the operation is finished, the following window is displayed.
(5) Take out the floppy disk, and then click [Finish] button.
Proceed to chapter 4.5 after rebooting the personal computer.
Downloaded from ManualsNet.com
4. Setting up MELDASMAGIC64 System
4.4 Setting Up Runtime Library
search engine
* For ISA NC Card, the [Card setting] does not exist.
* For WindowsNT, [General] and [Driver] tabs do not
exist.
67