Confirming Nc System Device Driver Operation - Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual

4.3.1.3 Confirming NC System Device Driver Operation

Confirm the installed Device Driver operating normally according to the procedures below.
Open Device Manager.
[Procedures]
(1) Turn on the personal computer.
Operation: Windows starts up.
If the message below is displayed for the version B5 or later of NC System, reboot Windows.
Press the [OK] button and wait for about 30 seconds, then Windows starts up. After the startup of
Windows has finished, reboot Windows once.
Caution: The operation above is necessary only once right after installation. Since this message is
(2) Click the [Settings] - [Control Panel] menus of the [Start] menu.
The "Control Panel" window appears. Double-click the "System" icon.
Downloaded from ManualsNet.com
4. Setting up MELDASMAGIC64 System
4.3 Setting Up NC Card and Device Driver (ISA Card)
not displayed for the NC System version B4 or older, the operation above is not
necessary.
search engine
40