Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual page 55

(13) Files are copied. A message prompting a disk change is displayed while the files are copied.
Insert the floppy disk into drive A according to the message, and then click [OK].
(14) Copying the files is continued. When the copy has finished, the finish window is displayed.
Click [Finish].
(15) The "System Settings Change" window is displayed.
Click [Yes].
(16) Windows is shutdown, and you can turn off the computer.
(17) Turn off the personal computer. (In some cases, the personal computer is turn off automatically.)
Now installing NC System Device Driver has finished. Proceed to chapter 4.3.2.2 "Mount NC
Card."
!
CAUTION
Do not turn on the personal computer until you mount NC Card according to the procedures of
chapter 4.3.2.2 "Mounting NC Card." If you turn on the personal computer without mounting
NC Card, the personal computer may not start up properly.
Downloaded from ManualsNet.com
4. Setting up MELDASMAGIC64 System
4.3 Setting Up NC Card and Device Driver (ISA Card)
*Take out the floppy disk.
search engine
49