Checklist (Isa Nc Card) - Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual

6.2 Checklist (ISA NC Card)

If a problem occurs during setup, check the items below.
<Items to be checked after the personal computer is
turned off>
!
CAUTION
Be sure to turn off the personal computer before
confirming the items below.
1. Check that all the cables are correctly connected.
2. Check that the mounted NC Card is securely inserted into the
PCI bus slot.
3. Check that the rotary switches on NC Card (DPADR,
IOPADR, and IRQ) are set up properly.
<Items to be checked after the personal computer is
turned on>
1. Check that NC System Device Driver has been
installed.
2. Check that Runtime Library has been installed.
3. Check that an NC Card number has been set properly.
4. Check that the utility and MELDASMAGIC Monitor have
been installed.
5. Check that the memory address and IO port address
set on the rotary switch of NC Card is the same as
those selected on the way to installation.
If the problem is not fixed even after carrying out these steps, try operations again after turning on the
personal computer again. If the problem still remains, refer to chapter 6.3 "Troubleshooting."
Downloaded from ManualsNet.com
6.2 Checklist (ISA NC Card)
search engine
6. Troubleshooting
Refer to:
4.3 Setting Up NC Card and Device
4.3 Setting Up NC Card and Device
4.3 Setting Up NC Card and Device
Refer to:
4.3 Setting Up NC Card and Device
4.4 Setting Up Runtime Library
4.4.3 Assigning an NC Card No. of
4.5.1 Installing the UtilityInstalling
4.3 Setting Up NC Card and Device
76
Driver (ISA NC Card)
Driver (ISA NC Card)
Driver (ISA NC Card)
Driver (ISA NC Card)
ISA NC Card
MELDASMAGIC Monitor
Driver (ISA NC Card)