Huawei TE30 User Manual page 21

HUAWEI TE30 Videoconferencing Endpoint
User Guide
Parameter
Network
interface
mode
PPPoE
Issue 01 (2013-03-27)
Description
Specifies the working mode for the
network ports on your TE30.
l Auto detection: When accessing a
network, your TE30 automatically
negotiates with a remote network
device to determine the optimal work
mode.
l 10 Mbps and half duplex: The data
transmission rate is 10 Mbit/s, and data
cannot be sent and received
simultaneously.
l 10 Mbps and full duplex: The data
transmission rate is 10 Mbit/s, and data
can be sent and received
simultaneously.
l 100 Mbps and half duplex: The data
transmission rate is 100 Mbit/s, and
data cannot be sent and received
simultaneously.
l 100 Mbps and full duplex: The data
transmission rate is 100 Mbit/s, and
data can be sent and received
simultaneously.
Specifies whether your TE30 accesses
broadband networks using dial-up
connections.
NOTE
If you set this parameter to Enable, you must
also set Dialing mode, User name, and
Password.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Setting
The default value is Auto
detection.
NOTE
If the remote network device you
want to communicate with has its
network interface mode set to 10
Mbps and full duplex or 100
Mbps and full duplex, set this
parameter to be the same as the
remote network interface mode.
Otherwise, communication fails.
The default value is Disable.
3 Network
13