Connecting A Vpm220W - Huawei TE30 User Manual

HUAWEI TE30 Videoconferencing Endpoint
User Guide

5.1.2 Connecting a VPM220W

After a VPM220W connects to the TE30 over Wi-Fi, the TE30 automatically uses the
VPM220W instead of its built-in microphone to pick up sound.
Prerequisites
The Wi-Fi hotspot function has been enabled on the TE30. Wi-Fi parameters have been set as
follows:
l
l
For details, see
Procedure
Step 1 Press the power button at the bottom of the VPM220W to power it on.
The VPM220W automatically scans for available Wi-Fi networks.
l If a VPM220W was once connected to your TE30, the connection between the two is
l If the VPM220W is used for the first time or fails to obtain an IP address, proceed to
Step 2 Touch and hold the center button on the VPM220W surface for 5 seconds.
A confirmation dialog box is displayed.
Step 3 Select Confirm.
The VPM220W sets up a WPS connection with the TE30 and attempts to obtain an IP address.
After the VPM220W obtains an IP address, its indicator is steady blue.
----End
VPM220W status indicators quickly provide information about the VPM220W working status.
Table 5-3
Table 5-3 VPM220W indicator status
Indicator Status
Microphone indicators all red
Microphone indicators all blue
Microphone indicators off
Issue 01 (2013-03-27)
The encryption mode has been set to WPA-PSK or WPA2-PSK.
DHCP has been enabled, and Start IP address and End IP address have been set correctly.
Setting Wi-Fi Hotspot
automatically set up, and you can skip the following steps.
2 and Step 3.
describes the status indicators.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Parameters.
VPM220W Status
Microphones in all the three directions are
muted and working correctly (not in sleep
mode).
Microphones in all the three directions are
unmuted and working correctly (not in sleep
mode).
The VPM220W is in sleep mode or powered
off.
5 Microphone and Speaker
Step
39