Charging unit and component
Checking the lighting coil (stator as-
sembly)
1. Measure:
• Lighting coil output peak voltage
Out of specification Measure the light-
ing coil resistance.
Lighting coil output peak voltage
(reference data)
Green (G)–Green (G)
r/min
Cranking
DC V
14.0
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the lighting coil coupler "a".
b. Connect the special service tool "1".
c. Remove the clip from the engine shut-off
switch.
d. While cranking the engine, measure the
peak voltage.
e. Insert the clip into the engine shut-off
switch.
f.
Start the engine, and then measure the
peak voltage at the specified engine
speed.
g. Measure the lighting coil output peak volt-
age between all combinations of the con-
nectors.
Unloaded
1500
3500
45.0
102.0
a
Charging unit and component
Test harness (3 pins) "1"
90890-06870
Test harness (3 pins) "1"
YB-06870
h. Stop the engine, and then disconnect the
special service tool.
i.
Connect the lighting coil coupler.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
2. Measure:
• Lighting coil resistance
Out of specification Replace.
Resistance (reference data)
0.5610–0.7590
Green (G)–Green (G)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the lighting coil coupler "a".
b. Measure the lighting coil resistance.
G
G
c. Connect the lighting coil coupler.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5-26
a
G
GG
1
G
a
G
1
G
G
G