Rigging grommet mounting
Rigging grommet description
Pass all the rigging components through the
proper holes in the rigging grommet.
6
5
4
1. Alert indicator harness
2. Trolling switch harness
3. Main wire harness
4. Speedometer hose
5. Battery cable
6. 6Y8 multifunction meter harness (pigtail
bus wire)/gauge harness/Y-COP wire
harness
1. Remove:
• Nut "1"
• Nut "2"
• Steering retainer "3"
• Bolt"4"
4
1
2
3
2
3
1
Installing the battery cable
1. Install:
• Battery cable
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the plastic tie "1", and then re-
move the main wire harness coupler "a".
b. Remove the cover "2".
a
1
2
c. Route the battery cable "1" through the
bottom cowling.
d. Connect the positive and negative termi-
nals of the battery cable.
TIP:
The positive battery cable is marked with "+"
mark.
e. Install the rubber caps "2".
f.
2
1
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3-5
Rigging grommet mounting
2