2. Check:
• Shift position switch continuity
Out of specification Replace.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the shift position switch.
b. Check the shift position switch for continu-
ity.
Shift position switch continuity
No continuity
Switch position "a"
Continuity
Switch position "b"
c. Install the shift position switch. See "Shift
rod and shift bracket" (9-10).
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Checking the engine shut-off switch
1. Check:
• Engine shut-off switch continuity
Out of specification Replace.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the main wire harness coupler
or switch panel coupler.
b. Turn the engine start switch to ON, and
then check the engine shut-off switch for
continuity.
1. OFF
a
b
1. OFF
2. ON
3. START
A. Switch panel (704 binnacle mount re-
B. Tiller handle model and 703 side mount
Engine shut-off switch continuity
Removed
Installed
pushed in *1
c. Turn the engine start switch to OFF.
d. Connect the main wire harness coupler or
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5-33
Ignition unit and component
2. ON
3. START
mote control)
remote control
Clip
"a"
Button
*1 Tiller handle model only
switch panel coupler.
A
b
a
B
a
b
Terminal
"b"