Technical specifications
Article number
Current-sourcing
Digital outputs, parameterizable
Short-circuit protection
•
Response threshold, typ.
Limitation of inductive shutdown voltage to
Controlling a digital input
minimum pulse duration
Digital output functions, parameterizable
Freely usable digital output
•
•
Digital output with time stamp
•
PWM output
–
Cycle duration, parameterizable
ON period, min.
–
–
ON period, max.
Resolution of the duty cycle
–
•
Digital output with oversampling
Switching capacity of the outputs
with resistive load, max.
•
•
on lamp load, max.
Load resistance range
lower limit
•
Output voltage
•
Type of output voltage
•
Rated value (DC)
•
for signal "0", max.
•
for signal "1", min.
Output current
for signal "1" rated value
•
•
for signal "1" permissible range, min.
for signal "1" permissible range, max.
•
Output delay with resistive load
•
"0" to "1", typ.
"1" to "0", typ.
•
for technological functions
–
"0" to "1", typ.
"1" to "0", typ.
–
Parallel switching of two outputs
70
6ES7615-4DF10-0AB0
Yes; Optionally as a P-switch or high-speed push-pull switch (high-
speed output)
Yes; 8 DI/DQ (X122/X132, SINAMICS Integrated) + 8 DI/DQ (X142,
PLC)
Yes; electronic/thermal
X122/X132: 1.4 A / X142: 0.9 A (high-speed output: 0.7 A)
X122/X132: max. -60 V / X142: max. -64.5 V
Yes
2 µs; For high-speed output, single pulse
Yes; Max. 8 (X122/X132) + max. 8 (X142)
Yes; Max. 8 (X142); e.g. for output cams
Yes; Max. 8 (X142)
Yes; Base frequency 1 / 2 / 4 / 8 / 16 kHz; specification of interpulse
period ratio over 32-bit pattern
0 %
100 %
3.125 %
Yes; Max. 8 (X142)
0.5 A; 0.4 A for high-speed output
5 W
48 Ω; with 24 V DC supply
DC
24 V
28.8 V
20.4 V
0.5 A; 0.4 A for high-speed output
2 mA
0.6 A; 0.48 A for high-speed output
100 µs; For X122/X132; at 48 ohm load
150 µs; For X122/X132; at 48 ohm load
1 µs; For X142
1 µs; For X142 as a high-speed output; 150 µs for standard output
6ES7615-7DF10-0AB0
SIMATIC Drive Controller
Equipment Manual, 11/2022, A5E46600370-AC