Siemens SIMATIC S7-1500 Equipment Manual page 80

Technical specifications
Article number
Isolation
Isolation tested with
Degree and class of protection
IP degree of protection
Standards, approvals, certificates
CE mark
UKCA mark
cULus
RCM (formerly C-TICK)
KC approval
EAC (formerly Gost-R)
Suitable for safety functions
Highest safety class achievable in safety mode
Performance level according to ISO 13849-1
•
• SIL acc. to IEC 61508
Probability of failure (for service life of 20 years
and repair time of 100 hours)
– Low demand mode: PFDavg in accord­
ance with SIL2
– Low demand mode: PFDavg in accord­
ance with SIL3
– High demand/continuous mode: PFH in
accordance with SIL2
High demand/continuous mode: PFH in
–
accordance with SIL3
Ambient conditions
Ambient temperature during operation
• min.
• max.
Ambient temperature during
storage/transportation
• min.
max.
•
Altitude during operation relating to sea level
• Installation altitude above sea level, max.
• Ambient air temperature-barometric pres­
sure-altitude
configuration / header
configuration / programming / header
Programming language
80
6ES7615-4DF10-0AB0
707 V DC (type test)
IP20 control cabinet installation / open type
Yes
Yes
Yes
Yes
Yes
Yes
Yes; e.g. emergency stop, acknowledgment button
PLd (PLe if exclusively F-CPU is used)
SIL 2 (SIL 3 if exclusively F-CPU is used)
< 14.00E-04
< 2.00E-05 PLd (if exclusively F-CPU is used)
< 14.00E-09
if exclusively F-CPU is used: < 1.00E-09 (at a site altitude of up to
3000 m); < 2.00E-09 (at a site altitude of more than 3000 m and up
to 4000 m)
0 °C
55 °C
-40 °C; Long-term storage: -25 °C
70 °C; Long-term storage: +55 °C
4 000 m; as of an altitude of 2000 m, the maximum ambient air tem­
perature is reduced by 7 °C per 1000 m; see SINAMICS documenta­
tion for SINAMICS S120 drive components
Permissible air pressure: 620 hPa ... 1 060 hPa
6ES7615-7DF10-0AB0
SIMATIC Drive Controller
Equipment Manual, 11/2022, A5E46600370-AC