Table of Contents
Advertisement
Chapter 1: Overview
•
Coaxial Cable Connectors to Remote Antennas - Two standard 75-Ohm connectors
are provided for the coaxial cables that connect the Access Point to its Remote
Antennas. Each coaxial cable carries RF and DC sense signals from the Remote
Antenna.
Note If an installed, powered Remote Antenna becomes disconnected from its Access Point via
its Coax/UTP cable bundle, you must reconnect the Coax/UTP cable bundle to the RA and
Access Point, and then cycle power to the connected Access Point before the RA can re-
establish communications with the Access Point.
Smart-hopping Access Point Status LEDs
The Smart-hopping Access Point provides the following status LEDs on the front panel of
Front Panel
the Access Point. At initial power on the Access Point runs a Power On Self-Test (POST).
During the POST, the LED indicators flicker illuminate continuously (AMBER) to indicate
correct startup operation. Next, the Power ON LED illuminates (GREEN) continuously to
indicate that the 48-V DC power and sync signal are being supplied, and the other two
(AMBER) LEDs turn change color (or turn off), depending on the status of the Access
Point.
Table 1-2 summarizes the status the Access Point LEDs:
Power/Sync
Flashing
1-8
LED1 -
LED2 - Network
Green
Flashing Green
Flashing Green
Green
Green
Flashing Green
DRAFT - 03 JUN 2022 13:32
Table 1-2: Access Point Status LEDs
LED3 - Radio
LED4
Flashing Green
Off
Flashing Green
Off
Flashing Amber
Off
310236883
2022-06-07 19:50:31
--------------------------------------------
Remote Antenna Status
Access Point Status
Power/Sync, Network, and Radio
are working properly.
The Access Point has lost remote
synchronization. Check remote
(upstream) synchronization.
Power/Sync, Network, Radio,
and Remote Antennas are
working properly.
Advertisement
Table of Contents
