Table of Contents
Advertisement
Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
Installation
1
2
3
2-4
Using a 7/32-inch drill bit, drill two
pilot holes 0.219 inches (5.5 mm) in
diameter, 3.394 inches (100 mm) apart
(from the center points of the holes),
and horizontally level with each other.
If the screws are going directly into the
wall (not into building studs), tap a
supplied plastic screw anchor into each
pilot hole until it is flush with the wall
surface.
Place the mounting bracket against the
wall and line up the two holes.
DRAFT - 03 JUN 2022 13:32
Required Tools
Phillips head screwdriver
Marker
Advertisement
Table of Contents
