Table of Contents
Advertisement
Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
4
5
6
2-18
Place the ceiling tile, with the
unfinished side facing you, over the
Access Point and Cosmetic Cover.
Make sure the Access Point is aligned
along the bottom edge of the
rectangular cutout in the ceiling tile
(the bottom edge of cutout refers to
the edge furthest away from the mark
you made on the tile when preparing
the tile).
This leaves space for the minimum
bending radius of the cables.
Place the mounting rail over the Access
Point assembly, on top of the
unfinished side of the tile.
Make sure the Flush Mount label on
the Mounting Rail faces you and
the Cable Access label points toward
the Access Point connectors. Feed the 4
bolts through the holes marked F.
The Flush Mount Cutout arrows must
align with the rectangular cutout in
the tile.
Secure the Access Point assembly and
Mounting Rail to the tile:
• Place an M6 x 1 nut on each of the bolts
from the adapter plate that stick
through the holes in the mounting rail.
• Tighten the nuts and make sure you do
not over tighten the nuts, which may
break the tile.
DRAFT - 03 JUN 2022 13:32
Advertisement
Table of Contents
