Table of Contents
Advertisement
Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
6
7
2-38
To secure the nuts, place a push nut
over each of the bolts and push down
until it sits on top of each nut.
You can do this by hand or use a tool,
such as pliers or an open-ended
wrench
Pull the LAN cable and Remote
Antenna cables (if applicable) through
the 1-inch holes on the unfinished side
of the ceiling tile so the cable
connectors end up on the finished side
of the tile.
Note: If connecting to two remote
antennas, pull two cables through one
of the holes and three cables through
the other hole.
If using two Remote Antennas
(perform this step on both the RA1 and
RA2 connectors on the Access Point):
• Connect the Coaxial cables (from the
same side of the strand) to the RA
coaxial connector.
• Connect the RJ-45 connector to the RA
RJ-45 connector.
DRAFT - 03 JUN 2022 13:32
Push Nut
Advertisement
Table of Contents
