Table of Contents
Advertisement
Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
5
6
7
2-10
Mark two holes at the locations shown
in the illustration below.
Using a one-inch hole saw, drill out a
one-inch hole around the two marks.
This is for connector cables to come out
of the wall and attach to the Access
Point.
On the finished side of the wall, secure
the one-inch grommets to the one-inch
holes you drilled. You need adhesive to
secure the grommet
Attach the access point to the Cosmetic
Cover using the two M3 x 0.5 x8 screws.
Place the Access Point face down.
Place the plastic cover over the Access
Point.
Make sure the two holes in the plastic
cover align with the corresponding
holes in the Access Point.
Secure the Access Point to the cosmetic
ring by screwing in the two M3 x 0.5 x8
machine screws into the holes in the
cosmetic ring and into the Access Point.
DRAFT - 03 JUN 2022 13:32
Advertisement
Table of Contents
