Using Beam Adjustment Mounting Bracket Ms-Sfd-1-□ (Option) ·29 - Panasonic WUME-SF4D-2 Instruction Manual

2-4-1-1 Using Beam Adjustment Mounting Bracket MS-SFD-1-□ (Option)
Step 1 Insert the mounting plate of the base bracket into the base bracket mounting rail on the
back of the device.
Step 2 With the base bracket in firm contact with the device, tighten the two ultra low-head hex
socket bolts [M5 (length 5mm), opposing faces 3mm] that fasten the base bracket.
Tighten to a torque of 3N·m or less.
No gap between base
bracket and device.
<Side mounting>
Loosen the two hexagon-socket head bolts with washers [M4 (length 8mm), opposing
faces 3mm] and remove the bracket.
Change the orientation of the mounting bracket, and tighten the two hexagon-socket
head bolts with washers [M4 (length 8mm), opposing faces 3mm]. Tighten to a torque
of 1.5N·m or less.
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Mounting plate
Base bracket
Base bracket mounting rail
This device
Ultra low-head hex socket bolt for base
bracket
[M5 (length 5mm), opposing faces 3mm]
Hexagon-socket head bolt with washer
[M4 (length 8mm), opposing faces 3mm]
(Included with MS-SFD-1-□)
Mounting bracket
Base bracket
Mounting
29