Part Names - Mitsubishi Electric MELSEC iQ-F Series User Manual

2.4

Part Names

This chapter describes the names of each part of the FX5-ENET.
[4]
2-4.5 mounting holes
[3]
[2]
[1]
[13]
No. Name
[1] External ground terminal
[2] Link status display LEDs
[3] Extension cable
[4] Direct mounting hole
[5] Network status display LEDs
[6] Operation status display LEDs
[7] Extension connector (for next module)
[8] Modular jack for P1 (RJ-45) (with cap)
[9] Modular jack for P2 (RJ-45) (with cap)
[10] Name plate
[11] DIN rail mounting groove
[12] DIN rail mounting hook
[13] Pullout tab
2 SPECIFICATIONS
20
2.4 Part Names
[5]
[6]
[7]
[8]
[9]
Description
Connect an external ground. (Spring clamp terminal block)
Displays the link status of module. ( Page 21 LED display)
Cable for connecting the module when adding the FX5-ENET.
Screw holes (2-4.5, mounting screw: M4 screw) for direct installation
Displays the network status. ( Page 21 LED display)
Refer to Page 21 LED display.
Connector for connecting the extension cable of an extension module.
A port 1 connector for Ethernet network. Connect an Ethernet cable.
A port 2 connector for Ethernet network. Connect an Ethernet cable.
The product model name, manufacturer's serial number etc. are shown.
The module can be installed on DIN46277 rail (35mm wide).
Hook for mounting the module on a DIN rail of DIN46277 (35mm wide).
They are used when drawing out an extension cable.
[10]
[11]
[12]