Mitsubishi Electric MELSEC iQ-F Series User Manual page 34

Setting procedure
To use the e-mail function, use GX Works3 to set the module parameters. To verify the server certificate, configure additional
settings with Certificate Configuration Tool for FX5-ENET.
Note that the module parameters can be set from the buffer memory as well. If settings are configured with both Certificate
Configuration Tool for FX5-ENET and the buffer memory, priority is given to the settings configured with the buffer memory.
*1 Check 'E-mail setting change function enable flag' (Un\G4374) to find out which setting is being used.
GX Works3
Create a new project on GX Works3
and add an Ethernet module.
Set module parameters.
Create a program to send e-mails
using module FBs.
Write the project created on GX Works3
to a CPU module.
(Ethernet port on the CPU module)
Are certificates sent from
the server verified?
When creating a program that sends e-mail messages using a module function block, refer to the following
manual.
MELSEC iQ-F FX5 Ethernet, EtherNet/IP, CC-Link IE Function Block Reference
■Configuring settings with GX Works3
Configure settings for sending e-mails in "Mail Function Setting" of GX Works3. ( Page 82 E-mail settings)
■Configuring settings with Certificate Configuration Tool for FX5-ENET
This function is configured with Certificate Configuration Tool for FX5-ENET. (Page 85 Certificate Configuration Tool for
FX5-ENET)
For Certificate Configuration Tool for FX5-ENET, only the port of the Ethernet module can be connected.
For how to obtain Certificate Configuration Tool for FX5-ENET, refer to the following.
Page 63 Certificate Configuration Tool for FX5-ENET
4 FUNCTION LIST
32
4.3 Other Functions
Yes
No
Setting completion
Certificate Configuration Tool for FX5-ENET
Set the reliable certificate.
Write the certificate setting to
the Ethernet module.
(Ethernet port on the Ethernet module)
* 1