Huawei RP200 Room Presence Installation Manual page 48

12 Installing the RP200 Display (Method 2)
10.1
12.2 Installing the Display
(For Samsung-LH55DCE only) Adjust the brackets.
6-2
1. Loosen the four screws on the left and right of a bracket, adjust the screws in the lower part
to the position marked "8", and then tighten the screws.
2. Loosen the screw of the back clamp in the lower part of the bracket to adjust the back
clamp for subsequent display installation.
3. Adjust the other bracket in the same way.
Before adjustment
Just loosen the screws.
Do not remove them.
Mount the brackets at the back of the
7
7
displays.
The brackets provide holes for both M6
and M8 screws.Select holes based on
the included screws.
Mark "8"
CAUTION
Back
clamp
The TOP arrow should point
upward.
44
After adjustment
M6 M8