Huawei RP200 Room Presence Installation Manual page 69

Appendix A Elevating the Rack
9 Remove the rear access panel.
To elevate the rear plate of the rack, remove
11
the two M6 hexagon socket screws.
Use the M6 hex socket wrench
to remove the screws.
Adjust the height of the rear plate as
12
required.
NOTE
Elevate the rear plate of the rack and
stop when you hear a click.
CAUTION
Do not let any screws fall into the rack when
removing them from the rack.
10
Remove the upper front cover.
Use two hexagonal socket screws to
13
secure the rear plate.
65
Use the M6 hex socket
wrench to remove the
screws.
Hold the middle part of
the upper front panel
and lift it up.
Use the M6 hex socket
wrench to tighten the screws.