Huawei RP200 Room Presence Installation Manual page 53

13 Installing the TE30/VPC600
4
Install the crimping cover.
6
Install the rear cable cover.
Insert the crimping cover into the
bottle gourd–shaped mounting pegs.
Tighten the captive screws.
Insert the dowel into its hole.
49
Insert the TE30 cables
5
into the rack and pull
them out from the middle
part of the upper front
panel.
The yellow cable
is indicative.
DANGER
When mounting the rear access
panel onto the rack, watch your
hands.
7 Install the rear access panel.
1. Ensure that all required
cables are installed.
2. Insert the two dowels on the
rear access panel into the
dowel holes on the rack,
and push the panel up until
it is secure.
The following figure shows
the appearance of the rear
access panel.