Maintenance Of The Process Filter; Figure 5: Process Filter - ABB ZSD 2020 Operating And Installation Instructions

Central lubrication unit

Hide thumbs Also See for ZSD 2020:

Table of Contents

Date: 2021-01-13

Version: 1.5

6.2

Maintenance of the process filter

Clean or replace the process filter depending on its degree of soiling.

1. Switch off the central lubrication unit off at its local switch.

2. Remove the cover of the process filter by releasing the two finger screws from the central

lubrication unit.

3. Pull the lid with the process filter off the central lubrication unit.

4. Unscrew the process filter from the lid.

5. Clean the process filter. In case of severe soiling, replace the old filter with a new one.

6. Screw the process filter onto the lid and insert the assembly into the opening of the cen-

tral lubrication unit.

7. Secure the the components with the two thumb screws.

8. Switch the central lubrication unit into automatic mode.

Item

Operating and installation instructions

Central lubrication unit

Maintenance and Repair

Article description

Filling strainer

Article number

3HDA10100096995

Page 20 of 25

Table of Contents