Date: 2021-01-13
Version: 1.5
6.3
Maintenance of the oil filter
The oil filter cartridge cannot be cleaned. Replace it during maintenance work on the central
lubrication unit.
Figure 6: Oil filter
Replace the oil filter as follows:
1. Switch off the central lubrication unit off at its local switch.
2. Unscrew the used oil filter from the central lubrication unit.
If necessary, use an oil filter spanner.
3. Clean the oil filter mounting flange.
4. Fill the new oil filter with release agent.
5. Apply a little release agent to the rubber seal of the oil filter.
6. Screw the oil filter onto the flange.
7. Tighten the oil filter finger-tight.
8. Switch the central lubrication unit into automatic mode.
Article description
Oil filter
Table 9: Ordering information – fine filter
© 2021 ABB Automation GmbH |
Operating and installation instructions
Central lubrication unit
Maintenance and Repair
Article number
3HDAK0100007098
Page 21 of 25
en