Toshiba TOSVERT VF-AS3 Manual page 36

VF-AS3
bit Function
0 Failure FL
1 Failure
2 Alarm
Under voltage
3
(moff)
4 V/f switching status
5 PID control OFF
Acc/Dec switching
6
status
7 DC braking
8 Jog run
9 Forward / reverse run
10 Run/stop
Coast stop (ST =
11
OFF)
12 Emergency stop
13 Standby ST=ON
14 Standby
HAND/AUTO
15
(LOC/REM)
Acceleration time 1 (acc) and deceleration time 1 (dec) are worked when cmod isn't "Communication
(*1):
option". If cmod is "Communication option", Acceleration and deceleration time 1 are worked by c860,
c862, c863, c865. See "7.1.
0
Under in
No output
progress
Not tripped Tripped
No alarm Alarm issued
Normal Under voltage
V/f 1
PID control PID control
permitted prohibited
AD mode 1 AD mode 2
Forced DC
OFF
braking
OFF Jog run
Forward run Reverse run
Stop
ST=ON ST=OFF
No emergency Emergency
stop status stop status
Start-up process Standby
Start-up process Standby
AUTO
(LOC)
TOSHIBA Drive profile
- 35 -
1
-
Trip status includes [rtry] and
the trip retention status is also
regarded as tripped statuses.
When DeviceNet network is
disconnected, this bit becomes "1"
-
V/f 1: pt = setting value, vl,
V/f 2
V/f 2: pt = 0, f170, f171,
-
AD mode 1: acc, dec *1
AD mode 2: f500, f501
-
-
-
Run -
-
-
Standby: Initialization completed,
not failure stop status, not alarm
stop status (moff], , [coff],
[coff], [lstp]), ST =ON and
RUN=ON
Standby: Initialization completed, not
failure stop status and not alarm
stop status ([MOFF], [coff],
[coff], [lstp])
Enabled with [f750]="2"
HAND: Panel operation is enabled
AUTO: Operation method selected
[cmod] and [fmod] are enabled.
HAND
(REM)
Enabled with [f732]="0"
LOC: Panel operation is enabled
REM: Operation method selected
[cmod] and [fmod] are enabled.
" for the detailed information.
E6581818⑭
Note
vlv, vb, thra
f172,f182