Siemens SIMATIC IPC MD-34A Operating Instructions Manual page 77

Firmware setting
Timeout
Automatic Failo-
ver
Boot Type Order
HTTP Boot Con-
figuration
: This option shows only when "Network Stack" = Enabled.
1
Calling "Boot Type Order"
Select: "Setup Utility (Page 71)" > "Boot" > "Boot Type Order".
Firmware setting
Hard Disk Drive
USB
BEV
Others
Calling "HTTP Boot Configuration"
Select: "Setup Utility (Page 71)" > "Boot" > "HTTP Boot Configuration" > "XXX (Mac address of
the device)".
Firmware setting
Internet Protocol
MD-34A
Operating Instructions, 08/2023, A5E52427535-AA
Value Setting in deliv-
ery state
UEFI: IPv6
HTTP: IPv6
HTTP and PXE:
IPv6
UEFI: IPv4/IPv6
HTTP: IPv4/IPv6
HTTP and PXE:
IPv4/IPv6
0 - 10
Enabled
Disabled
Value Setting in deliv-
ery state
Windows Boot
Manager
EFI HTTP[IPv6]
EFI HTTP[IPv4]
EFI PXE 0 for IPv6
EFI PXE 0 for IPv4
Value Setting in deliv-
ery state
IPv4
IPv6
Firmware/BIOS description
Meaning
x
2 Delay time in seconds during booting so
that the user has time to press the hot-
key to open the firmware selection
menu.
x If it fails to boot the default device, it
will try to boot next device.
If it fails to boot the default device, a
warning messages will appear and then
it will go into firmware UI.
Use F5 or F6 key on the connected key-
board to change boot type order.
Configure boot parameter by MAC Ad-
dress via IPv4 or IPv6 protocol.
Meaning
x Change Hard Disk Driver boot order.
x Change BEV boot order.
x
x
x
Meaning
x Select the version of Internet Protocol.
7.2 Configure firmware
77