Dtc Check; Dtc Table - Suzuki GRAND VITARA 2005 Service Manual

4F-13 Electronic Stability Program:

DTC Check

1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(1).
Special tool
(A): SUZUKI scan tool
(A)

DTC Table

CAUTION
!
Be sure to perform "Electronic Stability Program Check: " before starting diagnosis.
DTC
(displayed
Diagnostic Items
on SUZUKI
scan tool)
NO DTC Normal
Longitudinal G sensor in
yaw rate / G sensor
C1015
assembly failure
Stop lamp switch failure
C1016
Lateral G sensor in yaw rate
C1017 / G sensor assembly failure
Brake fluid level switch
C1018 failure
Master cylinder pressure
C1020 sensor power supply failure
RF
C1021
LF
C1025 Wheel speed
sensor circuit failure
RR
C1031
LR
C1035
3) Turn ignition switch to ON position.
S5JB0B4604050
4) Read DTC according to instructions displayed on
SUZUKI scan tool and print it or write it down. Refer
to SUZUKI scan tool operator's manual for further
details.
NOTE
If SUZUKI scan tool can not communicate
ESP® control module, perform "Serial Data
Link Circuit Check: ".
5) After completing the check, turn ignition switch off
and disconnect SUZUKI scan tool from DLC.
1
I5JB0A450008-01
Detecting condition (DTC will be
set when detecting)
—
Longitudinal G sensor signal is out of
specified range. (for 4WD vehicle)
Vehicle behavior and stop lamp
switch signal is disagreed for
specified time.
Lateral G sensor signal is out of
specified range.
• Brake fluid level is too low.
• Input voltage of brake fluid level
switch to BCM is low.
Power supply voltage to master
cylinder pressure sensor in ESP®
hydraulic unit / control module
assembly is too low.
Wheel sensor signal is out of
specified range.
S5JB0B4604051
ABS EBD
warning warning warning
lamp lamp
— —
—
— —
— —
— —
— —
*1
ESP®
lamp
—
—