Advertisement
INSTALLATION AND CONFIGURATION
Disc drive performance
and reliability are dependent on the
type of media used.
Disc drive specifications can be assured
only when
using HP media.
The use of improper media can
result in premature disc failure or damage to the disc drive.
Never turn
the disc drive off or remove
the disc from
the
flexible disc drive when the disc access light or when the on
line LED is on; doing so can cause loss of data.
[2] CONFIGURATION OF STANDARD DRIVE UNIT
VOLTAGE SELECTION AND FUSING
The voltage select switch on the rear panel must be set to the nominal line voltage for the area in which it
is operating, Figure 3-2 shows the voltage select switch set for 115 VAC line voltage.
Always turn the AC power switch off or disconnect
the AC
line cord before changing the line voltage select switch posi-
tion. Changing the line voltage select switch setting while AC
power is on could damage the unit.
Qu >
"AC LINE
VOLTAGE
SELECTOR
Figure 3-2.
HP 9153A and HP 9154A Rear Panel.
3-2
Advertisement
