Advertisement
INSTALLATION AND CONFIGURATION
VOLUME CONFIGURATION SWITCH
Volume selection is accomplished by switch SW1 located to the right of the HP-IB connector at the rear of
the unit (see Figure 3-8).
The switch allows the user to divide the Winchester disc into multiple volumes.
These volumes can be formatted independently with different interleaves and can have different file sys-
tems on them.
To use this feature, the host must support multiple volumes.
If the host supports only a
single volume, volume 0, then this feature is of no use and should be set to the one volume setting. The set-
tings on the volume switch have the following meanings:
N
©
Co
S
o
S7
>
Swi
Y
ETTING
NUMBER OF
VOLUME SIZES (Moyte/VOL)
Allows re-initiaézing of existing volumes.
At first, if you leave the switch
at the factory setting of O,the hard disc is intialized as one volume: üt detults to 0).
Prevents writing to the first volume of the hard disc.
Prevents accidental
re—initializing of the hord disc.
Prevents accidental
re—initializing of the hard disc.
Volume Configuration Switch HP 9153/54A
SETTING
| NUMBER
OF
VOLUMES
VOLUME
SIZES (Mbyte/VOL)
Allows re—initializing
of existing volumes.
At first, if you leave
the swltc
factory setting of O, the hard disc ls initlolized os one volume
(It detaults to
ge
p
i A
T
Fi
7
n
2
10.08
3
:
Two
par
pa
Preventa
writing to the
first volume
of the
hard
diac.
Prevents occidental
re—initializing of the hard disc.
Prevents accidental
re—initlalizing of the hard disc.
Volume Configuration Switch HP 9153/54B
. 3-9
Advertisement
