REMOVAL AND REPLACEMENT
- Remove the two screws located on the side of the drive mechanism.
- Straighten the two tabs at the bottom of the shield assembly.
~ Pull the shield assembly from the drive mechanism.
SHIELD
——
ASSEMBLY
ASSEMBLY
Figure 6-1.
Rear View of 3 1/2-inch Winchester Mechanism.
me
1
110
|
Up for 9153A ond 9154A
Switches
1,2,and
4 must
be in the
position shown
for proper operation
in the 9153A/54A
products.
Figure 6-2.
Drive Select Switch.
- Remove the module by pulling it out of the chassis.