Advertisement
REMOVAL AND REPLACEMENT
3. Remove the three screws that mount the supply to the unit.
4. Lift power supply out of the unit.
5. Remove the two wires on terminals N and L located at the rear of supply.
Push shield onto the the power supply.
[10] DRIVE REMOVAL
Refer to Figure 6-8 for the jumper configuration of the drives.
1. Removal of the 3 1/2-inch flexible disc drive from drive mounting assembly
c. Remove the three screws that secure the drive to the drive mounting plate.
d. To assemble, reverse the above process.
c. Remove the three screws that secure the drive to the drive mounting plate.
d. To assemble, reverse the above process.
NOTE
Care should be taken to ensure proper fit of the flexible disc
drive front bezel into the front panel opening (9153A only).
6-7
Advertisement
